Scooter Battery Set Up
 |
 |
 |
| Battery in the box. |
Remove battery and Eloctrolytes from box.
|
Remove lid from top of battery in preparation to fill the battery with electrolytes.
|
 |
 |
 |
|
Remove caps from electrolyte container. Place on top of the battery. Lining up the holes. CAREFUL NOT TO SPILL ELECTROLYTES! Push electrolyte container into the battery. WEAR PROTECTIVE GLOVES!
|
Once electrolytes are secured into the battery, poke holes in the top of the electrolyte container releasign the electrolytes into the battery.
|
Once electrolytes are secured into the battery, poke holes in the top of the electrolyte container releasign the electrolytes into the battery.
|
 |
 |
 |
|
Squeeze all electrolytes into battery. Careful not to spill. Fill all the way to the top. If you spill some, top the battery off with water.
|
Replace lid. You can use a rubber mallet to secure, but be gentle.
|
Let battery sit for 1/2 hour. Then charge battery for 12-14 hours with a 2amp/12volt battery charger.
|
 |
 |
 |
|
Once battery is charged, Slide square nut into positive and negative terminal.
|
Attach bolt to negative wire, then srew bolt into negative terminal.
|
Attach bolt to negative wire, then srew bolt into negative terminal.
|
 |
 |
 |
|
Attach bolt to positive wire, then srew bolt into positive terminal.
|
Attach bolt to positive wire, then srew bolt into positive terminal.
|
Attach bolt to positive wire, then srew bolt into positive terminal. Place battery back into compartment on scooter.
|
|
| |
|
|
